Recent content by uavjoe

Mine did it too, sometimes even less than 100m, mainboard is fine... antenna connections on 5.8ghz signal gone bad, removed the glue on the connections, washed the u.fl connectors with isopropylol alcohol. And tested this weekend... Usually i got around 200m in an open field with a CE rc.. well...

I have opened the drone, removed all antennas, and very carefully inspected them, i could swear there was traces of corrosion on the coax cable at the connection, so i used clean alcohol, and dunked the u.fl connectors inside it for a minute or so.. i was even considering 100% lemon juice, but...

What does this mean.. recently upgraded the DJI go app and got this msg... These days i am affraid to activate or allow or even enable anything from dji...

And the antennas? Do they perform better than the stock antennas? Surely hope so

same issue. I did however remove the app and re installed it.. it didnt disconnect anymore(grey screen while flying), but with the lag, no luck.. i used an old vodafone tablet, no lag... On my brand new nokia 7 plus.... Terrible lag... I tried older version 3.1.5 on nokia and it did not even...

Lol seems like that is the only way.. one has to do your own thing on these... Thanks for the reply

Have you got all 4 antennas on the outside.?

Also did relinking.. but no luck. Only thing that was done prior to this was installing latest version of dji go app.. older version was giving map init error... Could the new software keep us back on this issue?

Im also having the same issue.. but havent had any luck yet.. cleaned antennas, checked all connections, and am considering the s20 chip removal mod, but my measurements are not ligning up with those who had the chip blown.. My drone is also still running the same firmware as it was fine...

Anyone knows why there are 2 antennas on the 5.8 ghz signal?

Hey all... Please shed some light on my question... I have had my p3 std for more than a year and was happy with distance (600m), quality etc.. however a week ago, after upgrading my phone and downloaded the latest android app, i started losing signal at -+100 meters and would trigger RTH, now...

Hey all, anybody got a good ohm reading on a chip that is not fried... Mine is about 50ohms on both readings.. but im having lost signal on 100m on RC

ribbon cable... check all connections.. or replace it.. or have it replaced as it is a delicate task.

hi to all, my p3s had gimbal vibrations. found the pitch motor shaft loose underneath the ribbon cable, kind of difficult to get to it but surely enough it stopped the vibrating cycles on my gimbal.. hope this helps to everyone that shared my furstration with jello and vibrating gimbals.

vibration on gimbal??? i tried all modes and fps and found some weights to balance gimbal done the trick...