Hey guys,
I had a bird that flew fine and had no problems except the video feed is sometimes sporadic so i decided to update fw to see if that would fix the video issue. Well i updated and it updated with no errors. Later when i tried to test fly it im getting esc status error. Turn off aircraft...
Maybe the device im using? its a lg stylo2 i have a nexus tablet 2013 ver coming on monday! But i cannot get into anything to do with the camera, cam settings, etc
i have a similar issue that i cannot even get to the camera settings at all. Nor do i have any control over the camera. Its says that the sd card is full but its empty.. I do not know what to do! Goes though start up fine. Any ideas?
found the problem with the battery error! it was a small two wire plug on new main board that i did not completely push connector into its slot for fear of breaking the new board. The cable comes from the 4 pin connector at the battery connection.
i found the problem with my battery error the communication cable for the battery was not completely plugged into its connector on the new board in my concern that i was going to damage the connector or the brand new board. so after completely plugging it in voila no more problems...for now
your right there is a small two wire cable that goes to the 4 little pins near the 2 large blades for the battery connection to a plug that is almost too short to plug in and i guess i was afraid of damaging the connector so that i didn't have it fully seated into the connector. After careful...
yes esc most likely bad, do u get an esc error when starting up? I had the same issue, replaced board and now getting battery error. not sure if i need to update fw or what?
Hello, I crashed my p3a and had an esc error and upon doing research i have concluded the main board needed replaced. Ordered one for 149.00 and replaced it yesterday. Now upon turning on the aircraft i see the p3a selftest the camera and then it has a beep every so often, the dji go app says...
I have two new dji batteries and after having to replace the main board due to an esc error that i got after crashing. So upon startup of the aircraft now the error on the dji go app says battery error and also shows 0% for battery. will not allow camera to work or starting the motors.
Do you...
Thațs a real bummer that u lost it! were u testing it out when u lost it? Do u think the esc error was the cause of ur loss? I too have a esc error when trying to start motors! I cant get past it however! Not sure what do do about it as I cant afford to send it anywhere for repair. I had to rob...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.