the forward two led lights , they turn red when craft is started up, csc.
but the one port side flashes red at the same time it sounds like the rotor is
turning off then back on.
the rear leds flash the normal green / reds for gps mode etc
I was looking at DJI warranty on a sellers website
and...
just unboxed a new phantom 2, mounted the gopro
went for a test flight and the port front rotor spins slow and makes
this start/stopping motion at idle and the light underneath flashes.
it seemed to have a hard time flying in one spot too, but it was a little breezy.
It just doesn't seem normal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.