Recent content by tristanb

Its not balancing the cell (or rather if it is, its still doing it 24 hours later). I've tried resetting the charger, and another cell of the same type that works great. I'm guessing this particular battery must have died then...

I upgraded to some mad dog 2700 batteries. They are great! However after the last flight the stock phantom charger stays blinking red and also blinking the 1s light. Any ideas?

You might want to check out something from 3DR - The do exactly what you want, and have RTF quads as well. http://store.3drobotics.com/

I orderd two sets, I'll let you know,.

Its a cutting matt, you can buy them at most craft stores, or: http://www.amazon.com/s/ref=nb_sb_ss_c_ ... Caps%2C208

So yes, I do indeed have the compass mounted on the opposite leg than where it was installed orginally. This is because my FPV wiring comes out the left side, so i moved it too the right. Is there a way to adjust in software, or do I need to re-wire the FPV (bit or a mission as I will have to...

Your a genius ticktock! I think I mounted the compass in the right leg (if LEDs are on back) and from checking photos I see the default is on the left. Ill try this, thanks so much. Out of interest is there a software solution to this or do I just need to remount. Fingers crossed, but I think...

No luck after tracing all the connections, and disabling the ghost / gymbal. Is there any form of diagnostics I can run? NAZA assistant shows GPS readings, sat fixes are ok, compass gives readings. I'm at a loss.

Well, last night I ended up going through the ghost, and all other wirimg no problems there and the NAza assistant shows no obvious error it gets GPS and compass readings. I'm flying in a field so location is not the problem. Really feeling stuck with this one... One thing i did find in the...

Hi there, I have a new phantom, I'm a heli pilot so not new to RC, but new to quads. I installed a CM2000 gimbal, and a FBOSD ghost, with a Predator FPV. I've tried the fly the phantom twice, I calibrate the compass, have the RC set to GPS and home lock, wait for the slow green lights, take...

Hi there, I currently have a Arris CM2000 powered from my phantom aux power cable. I have a predator, that currently has the filter board, so it can be powered directly from the battery balance cable. I'd like to not use this to power the predator as its a pain to plug in every time i change...

I'm having a few problems with mine, I made a new thread and I should have posted in here, apologies. I made a video of the oscilations I'm having, its only when rotates to the left, note the cable isn't fouling the landing gear, although it is close Heres the video. Any ideas...

I just bought and installed a new Arris CM2000 - its acting very odd when I tilt the copter to the left, like it can't hold enough power to keep the gimbal level. THe cables are not fowled by the landing gear, although it does look close. I made a video to show what going on, any ideas how to...

Hi there, I want to try and find a 90' extension, and a cable for the fatshark predator transmittor antenna, so I can route it more efficiently. Does anyone know what its called? (the socket), or know of a good place to buy this from?

Hi there, yes I already have the Phantom, and yes as you succinctly put it, I'm now going for bank account depletion... I'm aware that later on I will probably want to get another multi ...