Recent content by Trev23

I had a very similar issue losing power & dropping from 50m smashing both landing gear & the camera gimble arm. Nothing showed up in the logs it just stopped logging & recording at the point it dropped. I returned mine to JB HiFi who returned it to DJI Australia. They quoted $280 to repair which...

I didn’t check the serial number to see if it was the same drone. I read that other thread, it’s very strange that firmware could brick your batteries. I’m just wondering whether this message doesn’t really mean much at all as I am still getting the same functionality & performance from my drone?

It did show a variation on one cell but it was showing within the green range which I’m assuming is nothing to worry about as there was still a yellow & red range it could have gone into.

Well it’s showing the latest on controller & drone but I might just factory default everything anyway just to try that. I tried calling DJI to find out what the original issue was & advise of the battery errors but they just advised to do a controller initiated battery discharge & recharge. Find...

Yeah I have 2 batteries, my first flight back after repair was using the battery that I actually crashed the drone with so I did suspect the battery but on my second flight my other battery started bringing up the same error message after it got down to 30% I’ve never seen the error before in...

Hi Guys, I recently had an issue where my Phantom 4 Pro+ seemed to just completely power off and drop to the ground mid flight. I converted my logs and there was no errors at all, just showed flying at 45km/h at 100m then nothing, even the video just stopped (after I recovered the clip that...

Yeah it didn’t initiate RTH and the joystick functionality was still working so I’m thinking maybe it could still see some form of communication so didn’t return. But had no video or onscreen options even with the drone right next to me it didn’t reconnect until power cycle. So if you were in a...

Hi guys. Just reading over this old thread as I have just purchased a P4P+ and updated firmware in controller & drone before I even flew. Have done a few flights without issue but yesterday while out about 800m away & 100m high my controller screen froze & popped up a message saying not...