As promised, here is my Set up. I like it very clean so all the FPV is installed inside with exception of the Antenna.
This is all whats on it right now.
P2 with zenmuse h3-3d with hero 4 black on it
Has a immersion 600w with Ibcrazy antenna's
Black Pearl 7ch receiver
Iosd mini
Dslr carbon...
last week i had a video issue from the go pro not sending, end up being a bad ribbon cable that plugs into the camera, but i would work on it of half hour to forty five minutes at a time powered up on my desk, my TX got warm to the touch, never got hot, and definitely never got anywhere near hot...
Since this will be images of peoples set up lets put it here, no matter what you fly lets see it, this includes controllers also. I will get mine up in the morning and send some images out with the new antennas on it. don't be shy who will go first.
I forgot, I also have the Mini Iosd in there also, the wiring for that needs to come from DJI short, or so we can plug it right into the cam port, which now also lives inside. there is a good amount of coiled wire that i would like to get rid of if i had the chance.
well, it does not touch the battery, as there is almost a inch between the TX and the battery, I did that so if i needed to get in and change frequency i can just pull the top off real fast and change it out. my tx does not get very warm at all, most likely because it is 15 degrees here and...
Here is my set up, I am a big fan of having a very clean look and feel, as well as I think keeping it looking clean loos a bit more professional then having stuff taped and Velcro to the outside., gets plenty of cooling with the vent there. have new antenna's getting in tomorrow.
I tossed the old part, It was barely visible, I was flying and tapped a tree the day i figured it out and crashed, when i was cleaning and looking things over i noticed that it did not look correct so investigated a bit more and found that it had a slight tear in it. I could also see the cables...
no no IOSD, but I believe I found the problem, the cable that goes from the Zenmuse to the usb adaptor had a hair line tear in the bottom two pins, I ordered a new one when it gets in lets see if that fixes the problem, had to happen when I was downloading video from the earlier flight. Does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.