I agree completely! I ordered one and it came within 3 days. It took about 15 minutes to install. ( I ordered the Pro version with the securing bolt, so I had to drill a hole in the case).
I've been using it now for about two weeks and I'm very impressed with how solid it feels with my 8 in...
I really enjoy my t8j. It does everything I need it to. I just wish I could find a reasonably cost effective FPV display mount for it.
Regards,
Todd
Sent from my iPad using Tapatalk HD
If you've installed the new Upgrade Board, then you won't be able to use the BT module. It needs to talk to a S-Bus connector.
I had the same problem when I purchased the the iOSD Mark II unit.
Best regard,
Todd
Sent from my iPad using Tapatalk HD
Re: A spot of evening tinkering goes a long way... literally
Out of curiosity, what's the white stuff at the end of the longer antenna.. A dilithium crystal or something?
;)
Sent from my iPad using Tapatalk HD
The Airplane version comes with the centering spring. I chose the Heli version, but used the software to configure it for airplane mode for my DJI Phantom Quadcopter.
-Todd
Sent from my iPad using Tapatalk HD
Where does the GoPro camera go? It looks like it's basically an A.R. drone on steroids!
The legs are only an inch off the ground.
I'm a little suspicious of cad pictures that purport to have all these capabilities.
-Todd
Sent from my iPad using Tapatalk HD
Re: Input signal abnormal after i have installed Zenmuse gim
You may want to check the 8 pin connector connection. When I installed my upgrade board, I inadvertently caused it to unseat itself from the Zenmuse gimbal connection.
-Todd
Sent from my iPad using Tapatalk HD
I noticed from your video that your throttle was centered. You may want to lower it to off and see if that has something to do with the constant beeping.
Just a thought.
Good luck!
-Todd
Sent from my iPad using Tapatalk HD
Since you installed the Upgrade Board, you need to remove the Zenmuse module. Just connect the black cable from the gimbal mount and plug it into the port on the board.
From your picture, it looks like you'll need to redirect the cable through the hole in the leg that's on the same side as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.