I obviously didn't slice them on purpose. When I was reinstalling the antenna piece of plastic, the compass wire got caught. After doing research I found out that this is common and most folks are just leaving the antenna plastic out a bit and just glueing it, instead of trying to get it lined...
The kit I purchased had the compass with the landing gear. As I was trying to put on the plastic piece that attaches to the landing gear, I sliced the compass wire. I can't find a video on how to replace this particular piece.
Maybe the picture will better explain.
I did replace the landing gear, yes. I had some issues with that wire, I may have sliced it. I couldn't figure out how to replace the antenna piece without messing up the compass wire.
hey guys, I replaced the shell of my drone. Everything went smooth, but when I turned it back on there was this constant beeping with red light on the front of the gimbal. Been at it for about 10 minutes now.
Could it be I didn't connect something properly?
I am connected to my remote, but it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.