Darn! I've been stood up!
Looks like we got our wires crossed on the time or something.
Good news, though- when I toted everything out to the garage and tried to fire it up one more time, it went back to it's usual slightly to the right and flinching up and down routine, not the general spaz...
fascinating info here:
Mine is in-tact, so no super-glue needed. And my shaft is aligned on this one. This is the one I call the "middle"- the one that has so many videos devoted to it. And of course the only one I don't need help with.
pondering your list... It's helping me sort through what surely appears to be multiple issues at this point.
A) entirely possible and going to explore that on my phone call in a few minutes. I just don't understand how to tell if they're out of alignment on the outermost and innermost ones...
OMG- totally forgot latest discovery: The roller control that is supposed to move the camera up and down does not. Zero response.
Can't believe I forgot to post that- so sorry.
And I can't find a way to control that from within the DJI GO app.
And now the cake topper:
I decided to fire it up...
I had read your reply in my email and only got part of it.
Just now reading the rest about the pot. I'm not familiar with that at all. My supplier had mentioned "hall effect sensors," which he described as being "soldered" to the ribbon cable. The best I can figure/research, either he...
Or maybe I misunderstood completely- I'll find out in a little over an hour and post back to let you know.
I have this terrible feeling I'm going to try to do as instructed but wind up breaking something else <cringe> I've done pretty well so far. I've taken the camera/gimbal off and apart...
Thanks again for the input, mdowney.
When I hold the bell housing in my bare hands, turning the shaft just causes the bell housing to spin with it no matter how hard I hold it. Maybe that's the problem, that it's bound up?? But I can't imagaine that's the way it works. I mean, if the motor...
Thank you, mdowney58!
I'd found a youtube video about the CSC vs left down to shut down. I wonder why the manual says to do it that way if it doesn't work all the time? Or did I misread that??
Remember, I didn't just replace the cable, I crashed it :-/ so anything is possible.
I've seen lots...
I've read everything I can find here and elsewhere, watched youtube vid's, etc. And I have had help from the company that sold me the parts, but I'm not understanding their last instructions and hope y'all can help.
Background (skip to asterisks below if you don't have time for this): Not my...
Hello all and thanks in advance for letting me pick your brain.
I'm trying to help my dad get his P3 Pro running again.
He bought it (along with a host of accoutrement$$) back in January. He hooked it up to his Tab 4 using the GL300B and flew it 3 times successfully. All was going well until...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.