Recent content by -T800-

  1. -T800-

    Vision camera is dead, LED is dark

    Thanks Noël I see, you a camera connector is burn. See my files, the connector is not damaged. The red and black wire between 12.4 volts. The same voltage can be found in the camera circuit board..
  2. -T800-

    Vision camera is dead, LED is dark

    Thank you for Geo. I opened the Phantom and the camera. I have the resistance meter. I measured the white cable between the camera and the Phantom and all wires are fine. Both connectors are deep. I put a few drops of electronics cleaner of the connector and switch. Still the camera is dead...
  3. -T800-

    Vision camera is dead, LED is dark

    My phantom vision camera is broken. The back of the LED is dark. Supply of electricity cable has 12v and 9v. But still the camera is dead. I have not crashed. Wifi is also down. Has anybody else had a problem like this? Can I do something?
  4. -T800-

    Phantom 2 Vision ground station issue

    Yes. The camera must be the last software, only then ground station works. Thanks.
  5. -T800-

    Phantom 2 Vision ground station issue

    I have exactly the same problem.All software is the latest, without camera. Maybe I need to update it
  6. -T800-

    New Firmware available

    If less than 6 satellites (more than 20 sec), and you fly over water. Occurs in the water landing?? :o
See more