Recent content by T303

  1. T

    Australia RePL

    Yes, the regs allow this, but IMHE good luck finding a "local" CASA flying ops officer who has a delegation for anything, let alone RPAS (and believe me, under "cost recovery" you can't afford for some Canberra FOI to come and watch you). Any enquiries to local CASA staff result in advice to...
  2. T

    P4P v1 Battery signal error and spaz out

    You didn't cut and splice the motor wires when you replaced them? I would probably be going back in looking for a wiring issue or connector that may have been disturbed (had that happen to a compass leg connector when doing a shell replacement, it was only pulled by a mm or so, but that was enough)
  3. T

    Controller pulsating

    I had that happen when I plugged in an unsupported controller (I2 without enterprise edition Sim), does the program actually respond to the RC commands?
  4. T

    GL6D10A RC connecting with P4P, help please?

    Hi All, I have a P4P with GL300 RC and inherited a GL6D10A RC, noting on another post that it will work with the P4P? I have tried with no success to get it to connect, and can only assume that it must be a firmware issue that locks the RC into thinking it is solely an I2 RC. Can any of you...
  5. T

    Leg Cracks

    That's not duct tape, that's genuine aluminum speed tape, It's about .5 to 1mm thick and will stay on up to at least mach .80 in the right spot. I have a roll purloined from somewhere in the toolchest and it is a good bit of kit!