I just wanted to say I had a similar problem with my drone after an update. I ended up ordering another main board. I need fixed my problem where my drone would not go very far at all. It may be possible that someone sold you a good motherboard but they did not distance test it. Anyway I’m not...
I too had this problem with that chip on circuit board.. I ended up ordering a whole motherboard and it solved the signal issue . Now only thing is I’m scared to update . And it never says homepoint set check it on map anymore .. makes me nervous .. anyway just figured I’d post in here and see...
I deff want to hear the results ! I tried to have mine done but finally I messed it up bad lol but I did order a new motherboard board and it’s perfect now like it was when I got it
Yes I took mine to a guy who repairs electronics and he was just not set up for something that small so after he tried I also got my stuff! And I tried ! But it was so small and I am no expert . Anyhow after I kept trying to get the small wire to stick across the chip. Finally you could not see...
For some reason my post didn't post on here last night ! I calibrated the imu and it's perfect now I flew 1900 ft it it was in the dark so I didn't want to push my luck! So all that being said the new esc main board fixed it and I am on the latest firmware and no problems at all ! So hopefully...
Fixed my bird completely I done the imu calibration and it's perfect now I flew it 1,900 ft so far with no problems and full signal ! It's night time so don't want to press my luck too much but . Main esc board replacement fixed it ! Hopefully this will help someone !!
I'm going to take it apart and check that because I have quite a feeling something happened just because he didn't do this until I took it apart and change that board I'm thinking maybe I pulled something to hard broke a wire or something but I mainly wanted to make sure it wasn't a software...
Awesome thank you I'm going to check that because I did change the main board out hope I didn't tighten down on wire or something it's weird because it just happens intermittently then give it a few minutes and it comes back on turns back green it says GPS again in the screen all I know is I...
Just changed my ESC main board out due to remote signal loss issues all that fixed now I'm getting a Compass error and it automatically goes into a TTI mode! Don't want to fly far off like that any suggestions first thing that comes to my mind is that maybe I left the Compass plug loose but I I...
Well got the new board in and all wired up.. now the funny thing is when I looked at firmware it's the new firmware !! Strange how a whole new board never been used can have current firmware but now for some reason I'm getting a Compass air intermittently if I didn't know better I would think...
Thanks ! Yea you're right it makes sense to me also I tell you I took the easy way out I bought a new esc board and I'm not doing any updates and hopefully this fixes it I read a thread or two where that's what they had to do is buy a new esc board from eBay so here goes nothing I will...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.