UPDATE: I replaced the receiver module and was able to link the controller to the receiver. Once I did this and reconnected the Zenmuse H3-3D gimbal, the Phantom Assistant software now recognized the unit as a "Phantom 2" instead of a "Phantom 2 Vision+". So my original question about whether...
No, the controller and the receiver won't link, that's the issue. When I turn the P2 on, the light on the receiver is solid red. When I press the button the light starts blinking red. I then turn on the controller and then release the button and the light on the receiver just goes back to...
I have uploaded the firmware on both the controller and the MC to the latest versions. I can't do any of the calibrations without the controller being linked to the Phantom though.
The error code is as follows:
"CFG-ERR: Configuration error, this may cause by firmware upgrade from old version.or abnormal Tx calibration. Re-calibrate your transmitter,and power cycle your controller and check all of the parameters."
Also, in the RC Tab of Phantom Assistant is a message...
It's the 2.4 GHz receiver that came with the P2 Non-Vision. The link between the controller and the receiver was lost after the crash so I've been trying to re-establish the link with no luck. I was thinking that the problem might be that the Naza unit was from a P2 Vision and it's expecting a...
Hi,
I recently had an issue with my Phantom 2 Non-vision which caused a crash and significant damage to the main control board and Naza MC. I purchased a new main control board (new) and a used Naza V2 from eBay. After receiving the Naza and installing with the new control board, the Phantom...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.