I removed and reconnected the gimbal and so far all seems fine. Much has been a loose connection. Thanks for your help all.
Sent from my iPhone using PhantomPilots mobile app
Reading about module 15 sounds like something to do with the camera. All cables look ok, but I'll strip the gimbal off later and reconnect and see what happens unless anyone know different? :)
Thanks
Stuart
Sent from my iPhone using PhantomPilots mobile app
Ok, it does seem there might be an issue with the firmware. It was already on the card, but on digging into the logs, I see every time I get the noise its because of a failure:
Summary logs shows:
========== 2014.01.01 00:00:13 remo-con disconnect======
Packet: P3S_FW_V01.08.0080.bin
Result...
Thats what I thought, but then it not being all the time I wasn't sure.
I installed the previous version of the firmware by putting it onto the memory card, then using the button the side of the drone to force it to use it (can't remember what the button it called, sorry). It accepted the...
It doesn't seem to be no, actually it happened on both batteries on Saturday, and stopped happening this morning when the batteries were swapped around again. If it was a firmware update issue would it not be constantly doing it?
Thanks for the quick reply.
I've taken a quick video of whats its doing (seems to AC interferes with the video for some reason)....
It happened every time I turned it on this morning to get the video, with and without controller. I swapped the battery and it stopped, so I put the original...
Hi All
I know this has been discussed before on this forum but I can't seem to get to the bottom of the issue. I'm hoping someone can help.
I recently had a firmware upgrade issue (turned off too early, not by me thankfully). I managed to resolve that by resetting the firmware. Since then...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.