Recent content by Steve7777

Yes, PTFE tape will do the job! See my tips on the subject here:- Are these props compatible with the P3?

Hi again, @pilot2 I finally remembered that I had bought a set of P3 Pro ND filters quite a few years ago - but because I have a such LOAD of drone stuff of all sorts, I had to track down where they were. I don't fly my P3Pro so much now because I usually fly my Mini2. My P3Pro was bought in...

Hi! I've just measured the outside of the camera-body thread on my P3Pro with a digital micrometer. I measured 3 times and the measurements were 29.81mm, 29.84mm and 29.85mm So the lens thread is probably 30.0mm. Plenty of ND sets available for P3 on Ebay. (LATER) BEWARE!! It seems DJI...

This question has been asked here before and these links should help you. You may find some more if you use the search facility here (magnifying glass, top right). For the calculations, the basic Phantom 4 has a field of view (FOV) of 94 degrees - whilst the P4 Pro has a FOV of 84 degrees I...

And here's a link to the downloadable manual and other things.... If that's not exactly the model you have, then select the correct page for your exact model from the menu on the left-hand side. https://www.dji.com/bg/downloads/products/phantom-2 (LATER) P2 user manual downloading in Chinese...

OK - I understand. Let's hope someone here is a user of the DJI Agras T16 and can help you.

That's a pretty specialised agricultural drone and that particular model has only ever been briefly mentioned here before. But I see you made the same post on another forum, which I won't name, but you should know where. You appear to have received some useful advice there from other users of...

Discharge it down to around two LEDs by leaving it switched on, putting it somewhere out the way so the beeping alarm won't annoy you. But don't forget all about it and let it discharge too far.

Further to dirkclod's message above, sometimes it's just the balance-charging circuit boards within the battery itself which go wrong as well. That was the problem with mine (discharging very quickly) so I removed the board and put some balance leads in so that I could charge and discharge it...

@Mdeblasi1991 I saw that you made another post, then seem to have changed your mind and deleted it. Unfortunately, I think that it's fairly unlikely that you're going to find someone here who has an encyclopedic knowledge of DJI HDMI boards, their reference numbers, physical appearance and...

Putting the reference number of the top left board into a Google Search seems to indicate that it's for a Phantom 3/4, which is also the same board as for the Inspire 1. http://www.fpvtv.co.uk/multirotors/dji-inspire/KIo03DJapaI/dji-inspire-controller-disconnected--fixed/ Maybe you could try...

Plenty on your nearest Ebay... drone pilot vest | eBay

No personal experience - but possibly a fluorescent vest with the words 'Drone Pilot' emblazoned on it would suffice?

Various bits of info about this have been drifting around for a while and this is the open categories list that is currently on the relevant official website in my European country (and yep - that's it at the full resolution). There have been a few previous threads here about it as well...

CW or CCW? I don't know where you are (possibly the postage will be too much) but perhaps you could buy a new one? - They are cheap enough... Search and you may even find cheaper than this CW example below...