Recent content by steve03258

That's correct. As long they are already paired you can fly without the gimbal.

I saw your post. I do not have an answer for that other than maybe you got a bad esc board. Have you checked all the cables thoroughly? I do not want to upset you, but sometimes it is easy to miss the alignment of those small flat cables. Have you tried the linking procedures mentioned in other...

Unfortunately on the P3 standard you need the initial wifi link for an all systems go to the processor when using the DJIGo app. I do not know about third party apps. If you obtain the initial link it will allow you to fly the aircraft even if telemetry is not present. I have only been playing...

The wifi is for video and telemetry information. It uses 2.4Ghz for transmit and receive of data. The receiver to actually fly the aircraft is in the main body. That is the shielded section you see. The aircraft receives the flight control on 5.4Ghz. This is the datasheet that is very similar...

The gimball board is bad. This is where the wifi chips are located. Mine will connect for about two minutes then disconnect. Try to reconnect and it disconnects even quicker, eventually disconnects before the app can even start. I sprayed freeze spray through the openings on the gimbal and it...