Recent content by Stan Davis

  1. S

    Crashed Standard 3

    I had the exact thing happen with my PS3 pro over two years ago. Auto take off, up about 15 feet and all of the sudden it shot wide open to the left and smashed into a tree. DJI was very accommodating and repaired the drone after viewing the data. There was no charge.
  2. S

    Controllers like stays red.

    Thank you so much. I will attempt to update it once again. The red light is on but the white lights also light up.
  3. S

    Controllers like stays red.

    I downloaded the latest firmware on to a thumb drive and put it into the controller. I turned on the controller controller and the light continues to stay read and nothing happens. Any further suggestions? Thank you so much for your input.
  4. S

    Controllers like stays red.

    I tried to update the controller with the latest firmware, It still stayed read. I will try again and thank you so much.
  5. S

    Controllers like stays red.

    I haven’t flown my P3 pro and when I went to update the firmware on the drone it seems successful. However when I turn on my controller the light is red and does nothing else. Please help.
  6. S

    Optimal frame-rate and resolution?

    I am shooting on 1080 at 30. beautiful footage. Take a look at the radio's signal meter and see if it is set to auto. If it is look and see which one of the channels is getting the least interference. Set it on custom and go to that channel. Below that you'll see a bar that you can slide that...