Recent content by SSR99

  1. S

    If you just purchased a brand new Phantom 2 Vision+ V3 READ!

    Re: If you just purchased a brand new Phantom 2 Vision+ V3 R I opened it up, and saw that I had no markings on the sticker, and for what its worth a blue mark on the capacitor. It seems to fly fine, and I really enjoy it...but am terrified to fly it. From what im hearing I should send it back...
  2. S

    Missed it ?

    So..after removing the cover, and thinking all was fine..I came across this....the discoloration in the black wire is freaking me out.....thoughts? Its from a V3 with no markings on the sticker. I DIDN'T notice this, until AFTER putting the cover back on...and went thru my pics....uggg
  3. S

    If you just purchased a brand new Phantom 2 Vision+ V3 READ!

    Re: If you just purchased a brand new Phantom 2 Vision+ V3 R Ok, I figured the pics out...pics to follow<;
  4. S

    If you just purchased a brand new Phantom 2 Vision+ V3 READ!

    Re: If you just purchased a brand new Phantom 2 Vision+ V3 R Ya..I was wondering if anyone would catch that<: I purchased it in Ontario and had my son bring it to me at Christmas, I live in Costa Rica. I got the top off, and the wires look fine, the solder looks solid, but the sticker has no...
  5. S

    If you just purchased a brand new Phantom 2 Vision+ V3 READ!

    Re: If you just purchased a brand new Phantom 2 Vision+ V3 R I removed the 4 tiny ( 2mm?) screws at the front of the motors, the 8 screws behind the motors, but is there 4 more screws to remove that are beside the landing gear?
  6. S

    If you just purchased a brand new Phantom 2 Vision+ V3 READ!

    Re: If you just purchased a brand new Phantom 2 Vision+ V3 R Just got back from a 3 battery flight. I purchased a new Vison V3 mid November from Canada Drones, In Ontario. I have not taken the top off to check the versions of the ESC's but my serial # is 645440*** . I have taken it out 10 times...
  7. S

    FWIW

    The last 8 times I flew, i used the DJI app to activate the compass calibration...it worked as advertised, and i saved hammering on the s1 switch. I know some here have been concerned, if flipping the switch, may cause unneeded wear on the controller. My 2 cents
  8. S

    2 quick green flashes

    Yup////Now that u mentioned it....I did notice the left stick was all the way down ...Thanks!
  9. S

    2 quick green flashes

    Hello all. Ive flown my V3 about 10 times, and no crashes..so far<; Today i saw the quick green flashes to tell me the home point was set..then the green lites flashes 2 times, and continued to do so. I had 10 satellites and the battery was freshly charged... Before it only flashed one green...
  10. S

    If you just purchased a brand new Phantom 2 Vision+ V3 READ!

    Re: If you just purchased a brand new Phantom 2 Vision+ V3 R I had a run in with a bush...dropped approx.4 feet and had a prop strike, the battery popped out. I reset the battery and fired it back up. One motor clicked and hesitated a few seconds and then it started up fine. I flew it 4 times...
  11. S

    Can't finish advanced IMU calibration

    Re: Can't finish advanced IMO calibration THANK YOU GUYS!! Yup, followed your instructions and it calibrated in 1 .5 mins. The knowledge base on this board is amazing,<: Never thought putting it in the fridge was a valid step, but yup, that did it.
  12. S

    Can't finish advanced IMU calibration

    Re: Can't finish advanced IMO calibration Also, each time i go into the Assistant, it tells me a advanced calibration is needed. It starts the calibration but hangs at 90% I let the calibration run for 45 mins... And now..the Vision will not turn on....uggh Thanks for any help.....
  13. S

    Can't finish advanced IMU calibration

    After a bit of a hard landing I plugged in the vision to see if it needed a calibration. I did a basic, then I went to advanced IMO calibration and and started that...it gets to a point and tells me it is too hot and reboot..so I click on ok..and reboot...and start over. It hangs up around...
  14. S

    Ummm How bad is it??

    So..beside the landing gear, everything seemed ok. But after I reinstalled the battery that popped out, on start up one motor clicked, hesitated about two seconds and started up. After it started it sounded fine, and responded as it should. I turned the vision off and on a couple of times and...
  15. S

    Ummm How bad is it??

    Hi all...had a bit of a hard landing...and this is the result....how do I fix it..everything seems to be fine, no prop damage, camera is good...so... can I just let it be <" Thanks!!~