Recent content by ss262

I just took another close look and noticed stress cracks on one of my arms, where the 4 screws that hold the motor attach, not the typical place where these crack. I did give it 2x 10 minute flights right after I did the firmware, before i noticed the shaking. I'm not 100% sure if the cracks...

I'm sure nothing can be told from this, but I recorded it: Sorry for the vertical video. Thanks everyone for your assistance.

I just did a propless wide open throttle bench test. I feel very very minimal vibration holding the face of my finger nail against the chassis. (nothing i would think would be out ordinary for spinning at that speed) At WOT you can see the gimbal pins vibrate but nothing transfers to the...

I agree, I don't see how that would be possible. Off to microcenter for new props... I will test than then install 1.5 again. I just wish I had paid closer attention to the gimbal on flights in the past.

What is the best method to check the motor hubs for balance?

That I'm not sure. I had it power cycled several times after 1.5 yesterday. Always seen that shake...

Well next step for me a prop balancer to eliminate that variable.

I still think it looks to vibrate a bit, but its not as bad as it was.

Ok downgraded to 1.4 and did nothing more: It looks to be gone or lessened.

Is this what you guys are seeing?

I have the same issue after upgrading from 1.3.4 > 1.4. > 1.5 on the craft and updating the RC firmware. Also did IMU re-calibration. You can see the whole gimbal assembly just shake after taking off and hovering. I just re-calibrated the RC and that did not seem to help. I'm going to try...