Recent content by spengbab

Impressive! Beautiful landscape, too. I don't think I'm that brave (or crazy!) enough to try this though :)

So, I tried it out with the default gains and observed the wobbling (I wish I grabbed a video, but it was the same as my post from yesterday). I increased the 'Vertical Gain' (under the basic section) to 180% and I no longer see the vibrating/wobbling... I'll need to try it out a few times...

Cheers, guys! I'll take it out somewhere where I'm able to test the stability a few metres in the air and see how I get on :)

They're still set to default - I've never adjusted them. Perhaps I'll go find a nice field, on a sunny day, with my laptop and try tweaking them. I've no BTU, yet (that's next on the purchase list)!

What? I don't think this is really going to go much further. Thanks for your suggestions and prompt responses, Jason :) If I manage to get to the bottom of it, I'll report back, in-case it helps another person with mystery squeaking.

Quite the opposite. I'd rather everything be in there. But, as I said, it was a last-ditch attempt to diagnose what's wrong because nothing else has resolved my issues just yet.

Yes, because I'm getting desperate/running out of ideas. You seem to have taken it personally. It wasn't intended to be a deliberate attempt to ignore you :) Yes, that was my mistake - I mixed you up with noiseboy72's thoughts on altering the gains... I've done multiple advanced IMU...

I've grabbed another video of the vibrating/squeaking, in daylight, just incase it demonstrates the problem better: Based on kenjancef's post, does anyone have any tips on how to diagnose a faulty motor? Perhaps I should contact DJI? Other than adjusting the gains, which jason suggests...

Thanks, I'll check this out :) Useful tip - I'll be sure to do that! I'm not quite sure what prompted you to say that? I've been extremely grateful for the tips and advice I've received. Ah, I've been calibrating the compass each time then :(

No problem, thanks for contributing! Assuming that you mean the spinney GPS dance, yep! I do that before each flight :)

I had the propellers on but didn't apply enough power to take off.

I assume this means you didn't do any recalibration or anything? I guess this isn't impossible! I did find the first set of screws very difficult to undo. The drone was upside down on a wooden floor, which I wouldn't want to mark, so I can't imagine I would've pushed down too hard. I gave the...

Hello everyone, apologies for my first post being a request for help, but I'm somewhat baffled by what's up with my Phantom 2, and I'm eager to get it up-and-running again. I miss flying :( Yesterday, I popped the top off my Phantom 2 and I performed a few upgrades: Fitted a mini iOSD, which...