Recent content by Specktech

Good to know. Nice info.

That was cool! Bet you didn't expect that.

That is really cool you have made this effort to get this drone back to it's owner.

Did you get it going? I had this same prob. I fixed it, it took me awhile. I learned alot along the way. You have to reset your transmitter. reload software. on drone and controller. run the vision calibration procedure..and the imu and compass. There are a few online vids about this same...

Nice post. Good to know info.

Make sure you keep all up dates current....The vision sensor calibration is one of the most important steps in this birds brains. Can be tricky using p.c. sometimes...Mac's supposed to work flawless with this calibration...Also only do it if you see lots of red errors. Also flying near...

My best advise...Check the battery connector...Alot of people slam that battery in there...It is quite fragile in there...They sell new battery connector boards...or take it out and re-solder all connections...look for rings around solder pads....I have had every board out of these birds and...

If you ever have to re-build the gimble you will understand the problem better. This area of the gimble is quite fragile. I would not torque it if you don't understand what you are re-positioning....If you pull the screws, drop the cam and ribbon cable. Get the cam in your hands and study it for...