Recent content by sjd

From a previous forum, here is the info to reset the P/W to the default 12341234. To reset the password, follow these steps. Turn on controller, turn gimbal dial to far right, and toggle S2 back and forth at least 3 times. Remote will sound long beep if the SSID and password for WiFi video...

Yes, that is correct. It uses barometric pressure to determine height relative to the Home takeoff position. If the drone flies over a valley the barometric pressure shouldn't change so it thinks it is at the same height AGL.

When this happens with my P3 standard, I have to do a Compass Calibrate.

I really don't know. I am just using the standard antenna which came with the controller.

I don't know. I am just using the standard antenna on the RC.

I get about 1800 to 2200 feet with the Phantom 3 Standard. When I want more distance, I use the app Litchi and set up a Waypoint mission. Even when communications is lost the misson is completed.

On the Mavic Mini, the Controller charges the phone when Connected. It probably also works that way for the Mini SE.

In Mission Hub, I assumed the setting of RTH is not RTH on loss of signal, but RTH after last Waypoint is executed. Is that not the case? That is what I have observed. Is there another setting?

When you start up Litchi, click on FPV on top left corner. Then click on your name on the right of 8 icons and click on Log Out.

I've been flying the P3 Standard now for 4 years. It uses wifi to connect to the Remote Controller. Maybe you need to read the manual.

I also have a Phantom 3. I power on the Drone first. Then power up the Remote Controller. There is then beeping and eventually the light on the Remote Controller goes Green and indicates that they are linked. Then I can connect to the wifi. If this isn't happening you can try relinking the...

My Mini came with a type C also. I bought an extra cable for a spare and use it. Here is the link to the cable I bought. https://www.aliexpress.com/item/4000156547707.html?spm=2114.13010708.0.0.764d4c4dHRPder

I believe it is standard on any Litchi Mission that the Drone completes the Waypoints. That's the way it works on all of my missions. You can configure what the Drone should do however when it hits the last Waypoint - RTH, Land, etc.

Have you tried the following?

Those are the ones. I bought one set and when I found out how good they were, I bought a spare set. I have run many flights with them without any problems.