Thanks, I'll look into it. One weird thing was when I went to update the firmware the SD card from the factory was jammed into the slot so hard I had to use tweezers to get it out. It's weird that I can see it, and format it when it's in the P3 though.
I might end up having to send it in I...
Ok, after the system has been plugged in for a few minutes the drive is now visible with only the empty DCIM file. The P3 is still acting like it's in a firmware update. I'm a bit worried I will run out of power before it is done with whatever it's doing.
I have formatted the card via the app. I even tried two different cards from my go pros.
When I plugs the P3 into my computer just now it is acting like it did when it was updating the firmware. I do not see it as a drive on my system, and the bird is beeping and blinking yellow.
Hey Gang,
Please forgive a n00b if this has been discussed already, but I assure you I used every ounce of Google-fu I have and came up with nothing. I have been reading this sight for over five hours now, and still can't figure out what I need to do here.
I turn the system on and get the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.