Recent content by Shawn1985

I just ordered the hdmi module for my p3p and I'm going to be using the fatshark dominator v3 goggles. What cord do I need so i can connect the remote to the goggles? I know that the goggle end of the cord is mini hdmi, but I don't know what the remote end of the cord needs to be.

DJI actually covered the shipping cost there and back. So I only paid for parts and labor. Shawn

FIXED Ok everyone, I finally got word from DJI about my "No Video Transmission Signal".They told me that my main gimbal board was bad and needed to be replaced. So as bad as I hated to spend the $, i went ahead and had them to do the repair and I now have a fully functioning drone with brand new...

I called DJI and went through the troubleshooting with the technician on the phone. After doing everything I have done multiple times they came to the conclusion that I have to send it back to California so their repair tech can do a diagnostic test. They covered the shipping cost from me in...

Do you just have to flash the board or do you need to replace a component on the board. Thanks, Shawn

When you have the 0800 and 1500 device not detected issue do you just have to flash the board or do you have to replace a component on the board?

Do you remember what dji did to your drone when you sent it in for the repair? Thanks, Shawn

I've used different mobile devices reinstalled the app, multiple cords, I've relinked the r/c 3 different times, and I've tried every trick that has been told to me. I even used a different r/c that works on my friend's p3p and still no live video feed. But thanks for the suggestion. Thanks, Shawn

How much did it cost for them to do the repair, if you dont mind me asking. Thanks, Shawn

I just tried that and , no luck. But thanks for the suggestion. Shawn

How could buying a new rc help, what did that do? I'm going to go see a friend of mine he has a p3p and I'll try his rc with my drone and if I get video then I'll know it's a board in the rc but until I can be sure I'm not gonna go out and buy a new rc they are quite pricey.

I have found that diagram and have went through it a dozen times, I've been battling it for about a week steady now. I started with no rc and ac link and not being able to get in the app, also I had a bad ribbon. Now I have full rc control can move gimbal and camera, full access to the iOS App...

I'm in the process of flashing the chip, my cousin is really good at stuff like that. So hopefully we can get mine up and going, if we manage to get it fixed we may be interested in doing it, I'll check with him and see what he thinks.

I have relinked the rc to the ac and I'm able to connect to the app with no problems.

I'm new to dji and I dont know how to revert to an older version of FW