Recent content by shadow7dji

I think my biggest problem might be a bent shaft. Bearings feel okay. Do the 2 motors work in series because all I'm getting is a beeping noise and consistent vibration as if they are trying to power up but are stuck?

Thanks for the response. Where are you located and how much would it cost for the repair and would it be less than replacing the gimbal and camera?

Ok. So it sounds like I will need to at least pop the motor casing apart and take a look at what's happening. Any suggestions on the best way to pull this apart? Sounds like it should come apart pretty easy as many seem to come apart on impact. I will say I had to press the housing back into...

Ok. I got it straightened by the motor isn't engaging. Just get the beeping sound and the "Remove Gimbal Clamp" message.

So help me...is the axle just setting in the bore or is it actually affixed. Does it spin or just act as a stationary rod around which the motor spins. Or more simply does it spin with the motor. I'm trying to determine if I will need to glue this in place in the bore as suggested. Or is the...

Can anyone suggest the best technique for bending the brushless motor mount frame back into alignment. Please see attached photo. TIA.

It appears I have found the correct place. Thanks Alot!!!!! But I need advice on one more item aside from the main topic of discussion. I need suggestions on the best way to bend the main frame that holds the motor back into alignment. Please see attached photo.`