I recently purchased a secraft transmitter tray. It has a place near the front of the tray for holding the bar under a nut device, what holds the back of the tx down?
I posted about this earlier, but on the recent cell tower job I was able to make in excess of $500 on the days I hustled.
In case no one has ever managed a large project where you have pick up labor such as this, you have to ask for help very early in the process before the final request...
I participated in the South Texas Cell tower inspection package that recently occurred. I flew several towers each day, easily enough to cover expenses +profit.
There was plenty of towers to fly and as many as I could do in a day. I could have done more if I could have been more efficient...
I am able to get authorization for a no fly zone, it shows up in my DJI go4 app that the controller has authorization, but the aircraft does not. The aircraft still shows ”no fly zone”
How do I fix this?
35m seems pretty low altitude. What kind of resolution are you going for? I have shot lots of 3d stuff on the DD and Altizure sites, they both recommend higher altitudes. I can usually get a resolution of less than an inch per pixel with altitudes of 200-250 feet
I was flying at a state park area (I called the range to make sure it was cool. They told me as long as I was not bother folks to have fun!) While there I was taking off in an area that was out of the way, but visible to most folks that were there to enjoy the place. I put out a couple orange...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.