Recent content by Sealbasher

I’m in Brisbane and travel to the north in winter. I fly a P3A and may get in touch if my travels take me that way next winter. Should have lots of room to fly up your way.

That’s what it was. Loose yaw arm screw. I’ve got the shaft moved around to line up the flat side with the grub screw and just waiting for Torx driver to come from EBay to tighten it up. Thanks everyone!

I’ve found a Camera Sideways Fix on YouTube which shows a loose or missing set screw. I’m going to watch it a few times then have a close look at my gimbal. I’ll let you know how it goes.

Yes, I might wait awhile as it’s a long drive to the nearest dealer here in Brisbane and they would want to send it away. I can still take vertical photos. Thanks

Tried the gimbal calibration and it returns to pointing hard left. Might have to take it to a drone doctor.

Yes, I took off from a level road. Right now on my kitchen table it goes through it’s startup sequence and ends up pointing hard left.

I went out to fly today and found that my camera was pointing hard left towards the front landing strut and would not return to centre. I always use the gimbal clamp when not using my P3. Any ideas about what I’m doing wrong?