Recent content by scubari

  1. S

    3.08 Discussion Thread for P2NV / P2Z

    When i connect p2 to assistant software i get a message that there is one bad cell in battery. Is it related to accidentally usage of battery to 0% charge ? ..i guess so, just confirming..
  2. S

    Zenmuse H4-3D announced at CES

    I'm using 3+ with h4 without problems.
  3. S

    GO PRO not working right

    Yeah, sorry ;) Gp 3+ be Transcend 300x 32gb hc1 class10 Fw 3.08
  4. S

    Tracker unit for P2

    I have rf-V16. Haven't noticed any interference. My unit is installed on p2 arm, not too near to antenna, kompas or gps.
  5. S

    GO PRO not working right

    I had same issues. I think it was because of sd card. try formating sd to it's default values.
  6. S

    Zenmuse H4-3D announced at CES

    Well, have you one allready ? ;)
  7. S

    Best carrying case?

    This is gooood :) http://www.goprocases.com/phantom2backp ... ition.aspx
  8. S

    Gimbal questions

    Sound from gimbal is normal. If you have your tx on and x1 lever set to normal in assistant and lever in upper position, camera should point forward after initialize.
  9. S

    3.08 Discussion Thread for P2NV / P2Z

    About auto-discharge..found this thread; viewtopic.php?t=28521
  10. S

    DJI has released the new firmware v3.08 for Phantom 2 series

    Re: DJI has released the new firmware v3.08 for Phantom 2 se Thanks, good info [emoji4]
  11. S

    Phantom 2 just going down for no reason??

    If there is, i have not found it..sorry. Mayby new firmware 3.08 works better, hope so anyway :)
  12. S

    DJI has released the new firmware v3.08 for Phantom 2 series

    Re: DJI has released the new firmware v3.08 for Phantom 2 se You dont need to uninstall. Just download 3.4, connect p2 and do the upgrade :)
  13. S

    heeelppp i reset my Gimbal and now is dead.

    Yeah, i allso got my old h3-3d back alive. this how i got it working after few attempts.. p2 connected to assistant software--pins shorted--power up p2--red-yellow light in gimbal--release pin shorting "cable"-- gimbal show up in assistant--update gimbal in assistant--power cycle p2, remember...
  14. S

    heeelppp i reset my Gimbal and now is dead.

    viewtopic.php?t=28033#p257443