I am still having the same shaking issues with my camera..was looking over it and saw this empty hole...it appears to be threaded...should a screw be there and could this be my problem ?
I have that on my phone but it won't let me post it...it goes back and forth real sharp and hard and the camera flips all around...I have tried calibrating, the rod in the back is level, I don't know what else to try but the camera still works...also on my app it say remove gimble clamp but it's...
I am still having an issue with my gimble and camera shaking very bad...i have enclosed a few pics...ribbon and all looks fine and all connections are secure...would like some expert eyes to take a look
Still having issues with my camera...have done the calibration thru software..i have a phantom vision 2 plus..on startup and always the gimble slings hard left to right...camera rotates back and forth...all my ribbons and connections are good....shaft is aligned properly in the back...PLEASE...
Sir : newby with a p2vplus....something is up with my camera...goes nuts when i turn it on...ive adjusted the rear rod and done calibration...i think a bird popped it as it was working fine and have not crashed it...the cam still works buts its goes from side to side real bad...any ideas ?
Took a video will not let me post...if you can contact me 4236199990 I can send to you...just did advance cali and no luck there either...don't know what's going on
no crash but when i turn my unit on the gimble slams fast from side to side and the camera flips upside down. I am brand new to all of this but i have taken the back plate off with the 3 screws several times and the rod is never in the same place when i level the camera up. the circuit board...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.