Re: Mystery of the FC40's camera holes (project started)
Wrap the string around the vibration isolator and use it to pull into place. Old car repair trick for intalling rubber grommets
Change the range for x1 in the software to adjust the endpoints for tilt. Forget exactly where its at, but its there somewhere. Had the same issue and it didnt require opening the radio.
What are you hoping to accomplish?
The fc40 kind of falls into the is what it is category for me. DJI did a good job with it and its well designed. I dont think there is a lot left on the table in a general sense. Especially anything that is cost effective.
Money would be better spent on a...
If your p2 is on 2.4ghz, and im pretty sure it is you do not want to be using a wifi enabled gopro to stream at the same time.
However, I use a hawking hwren wifi repeater to get more range out of my fc40 camera, and while I havent tried it with my gopro I have no doubts it will work.
Your...
I have a Hawking hwren2 and a 3800mah 12v rechargeable pack. I set up the repeater to be named just like the camera except I changed the last digit so I can tell the camera apart from the repeater with the app. Once setup it works very well. Spent about 50$ on the repeater and 20$ on the...
If you are using this as a dedicated battery to run the monitor while flying with a second battery I wouldnt do it unless your willing to sacrifice it. Essentially your running one cell out of balance. If you are loading the entire battery at the same time its not a problem. For instance...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.