Recent content by Rsmolag

Yes the flight over the ball field was after the guard was removed. I just went out and tested several times in the location with the buildings and all OA sensors on and it worked fine. Must have been a glitch in the initial firmwarw update

So I figured it out, I plugged the AC into assistant 2 and reset it to factory, then re-installed the firmware update and it worked no issues. No clue what happened but I am glad it is fixed. Thanks again for the help everyone

Ok so I took my P4 out this morning and narrowed the issue down to having to do with the RTH Obstacle Check feature. When ever this was enabled, the AC would again just fly to max height and hover. However if I disabled this feature and kept the Obstacle Avoidance feature on the AC would RTH...

https://www.phantomhelp.com/LogViewer/4JNR1CVDZVGH02F4LR4V/ Good new, you were right! When I turned the obstacle avoidance feature off it worked perfectly. So that leads me to believe one of two things. 1 - That you are correct about the sun 2- There may be something wrong with one of the...

Ok will do first thing in the morning. Ill make sure to turn obstacle avoidance off. Appreciate the help

When the 400ft flight was done, it was dusk and the AC was not facing the sun

How can I get you the .dat file?

Also there wasn't that much wind only about 7 mph. So not sure on the speed either

But does that explain why the AC is flying straight past the RTH altitude to Max altitude?

This is after, I just did this a few minutes ago

https://www.phantomhelp.com/LogViewer/8T2U5MAF34VK4BU6P1JY/ In this flight I set the RTH to 262ft I clicked RTH at 208ft and then it went all the way to the MAX just shy of 400 and sat there. Really not sure what the issue could be. I updated all of the firmware to the most current version...

Understood. But it also does this when the RTH is set to 40 and max was set to 400 ft. Can provide that flight log later tonight

https://www.phantomhelp.com/LogViewer/UBVNSUGR2FLPEQ45AKCR/ Here is another one of me flying it further away, when I click RTH, it just ascends to max height and hovers. I guess distance could be an issue since its not too far away but I am unfamiliar with the area I am flying so I dont want...

Sorry if I am being a pain, but when initiate rth it says that it will be returning to home but it does not it just hovers at max height. I will takw it out again tonight and change the max height so it is not the same as the RTH. I am confused as to why it is not returning and only hovering

https://www.phantomhelp.com/LogViewer/LF8EI8G0GQ14GX0R2NPJ/ https://www.phantomhelp.com/LogViewer/6OD73HLT1Z7X266KNWUB/ Here's a few more