I replaced all four motors. It took almost 2 and a half months to get two of the motors from DJI. After replacing the motors I had no problem getting my Phantom air born again. I ran approximately 10 batteries with no problem but today I charged-up 4 batteries and when I went to fly 1 motor was...
I connected to my NAZA assistant and my Compass readings were within > X 255, Y -109, and Mod 1591.8. I also removed all 4 props and spun the motors with my fingers and one motor seemed to have what felt like something binding within the motor. Can I safely remove the allen screw which secures...
Yes the only reason I pulled the screws out was to confirm that I used the proper screws, usually I read the instructions when I install something. When I installed the prop guards the only screws I only had to replace were the 8 outer screws which were originally short screws. I just pulled...
I am running prop guards, all 8 inboard motor screws are short and all 8 outboard screws are long. I've had these guards on ever since my Phantom was new and never had a issue with them.
I've tried running the motors to see if they straighten out, no luck. Nothing touching motors they are all running free. I pulled the pro guards off and all the correct screws are in place
I've been flying my Phantom 1 for a couple years with no problems. This year I charged up 4 batteries for a flight. As usual I powered up the receiver, installed a battery in the Phantom, lights went thru the powering sequence as usual. When I pulled both joysticks down to the left the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.