Recent content by Robert Boldman

The soldering was relatively easy for me, only because I do some electronic servicing for a living that requires soldering. I did however, have to use my cheater glasses, a fine point, low heat setting to do it. :) I will mention one thing I learned from my research, I'm not sure why DJI...

I just got done testing the new board, P01012.09 with the new motors and everything worked just fine. Flew for about 30 minutes totaland everything appears to be working well. I guess time will tell int e long run as far as any damage to eother the board or the motors. Again, based on everything...

The board came from Helidirect and motors from Camrise in Brooklyn, NY. Hopefully I'll have them by the week end. I already have the board in place and just have to solder in the new motors once I get them and it should be skids up..... I hope. I'll post how it goes as soon as I get it together...

I decided to just order new 2312A motors for my new P01012.09 board. From what I read, I looks like they should work with the P01012.09 board. I don't really care what the box says on the sticker, I'm going with the part number on the top of the board and to be safe I'm replacing the motors. I...

I had the same question/problem. My P3P took a hard landing and I had to replace the part #33, P01012.07 main board. I was sent me a new factory sealed DJI black box with "Part #33" on it, but the board in the box, had a P01012.09 part number on it. In reading the instructions was equally...