Bingo! It seems the answer is often far simpler than you think. Bad connections were the culprit due to the enamel. I sanded them down, tinned, twisted, then soldered and it works perfectly! Thank you @Oso and @cheddarman
That might be it... I just cut, twisted and soldered. I didn't know there was a coating on the wires but that would explain why the solder had trouble sticking. I'll give it a shot.
I recently purchased a "broken" Phantom 3 Pro and have been trying to fix it. Everything is working so far except for I am receiving the ESC error when attempting motor startup. I installed v1.11.30 FW and that didn't make a difference.
Condition of the P3P:
- All circuit boards seems okay...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.