Recent content by richmunton

A replacement clamp should fit in ok with a slight bend,, but looking at the connector under magnification the top row of pins look like they need to be compressed down so I don't think glue etc would work[emoji27]

I am watching eBay uk everyday[emoji106] but even broken stuff ends up at nearly £70 so as much as I would love spare gimble/ camera parts knowing my luck the only working parts would be the cable clamps[emoji33] was hoping that one of the many guys that repair gimbles would send me the clamp...

Does anyone know where I can buy a new ribbon cable clamp for 4K camera? Mine is in three pieces [emoji27]

Oh that sounds poo[emoji90] give me a few mins and I will search more info[emoji106]

If the card has not been formatted several times it can leave a ghost copy of the aircrafts firmware on the card and this will confuse the controller update

Have you tried to install the older firmware first?

Don't want to state the obvious but have you started and shut down the controller several times? Have you formatted the memory card a few times before you updated the controller?

Has it asked you to update in DJI go app?

I see on your other thread that you were talking to #bobmyers? Just wait till he is back online as he has been a great help to me[emoji106] and he seems to be a bloody nice guy[emoji119]

You are already in the best place for DJI support[emoji106] just be patient and someone will reply, there are some brilliant members here who have a vast knowledge of all things DJI, because it's a worldwide forum people come online at different times but the help and support is second to...

Unplugged the short one at both ends a couple of times , they both have power outputs because the yaw and pitch motors both buzz and vibrate when I calibrate the gimble,, just no video feed or movement?

I bought new gimble/ camera ribbon,,, haven't changed the gray ones though as they look perfect,, gimble never even popped a damper so gray cables were never stretched ?

Cheers Bob , have checked both already[emoji17] only problem I have is that DJI don't seem to repair individual parts on the gimble , they just quote you for whole new unit, and being as my yaw arm is bonded with aluminium apoxy I don't think they will do anything other than tell me to change...

I have done everything possible , Imu cal, compass cal, updated bird controller and app,, formatted two cards and also backtracked the firmware on bird and control.. Back on latest firmware now and still no camera or gimble,,, gimble makes a noise and buzzing during calibration just does not...

I replaced my yaw arm and ribbon but now have this error message[emoji22]