Recent content by richard shirazian

Well he sorted it out in like 3 mins..and told ne you just remove this bit of plastic..taken it out for 2 flights since and its spring loaded self centred now for sure..just like the right hand stick...all good for me..

Hi, Many thanks for the advice.. I took it to the retailer and he sorted it out in 5 mins..apparently it is already self centring but there is ratchet mechanism that inhibits this function, you take this lump of plastic out and hey presto! Now its just like the stock transmitter and all is...

Hi, The setup of the controls is the same, what I meant was on the stock TX the throttle is spring loaded and when released centres and the phantom just hovers. On the T8J if you let go of the throttle stick when your in a clime ..it stays where it is and continues to climb...and to get it to...

Hi, Being a novice at Phantom flying ( just a few weeks now) I can say I am totally hooked and have now upgraded to the a Futaba T8J TX / RC , the Zen-muse gimbal & the fat shark FPV setup and its all working now ( after a small issue with lid orientation)..but my only issue was the stock...

Hi, Being a novice at Phantom flying ( just a few weeks now) I can say I am totally hooked and have now upgraded to the a Futaba T8J TX / RC , the Zen-muse gimbal & the fat shark FPV setup and its all working now ( after a small issue with lid orientation)..but my only issue was the stock...

Your a legend mate!! Works like a dream now.. Should have put those stickers on LOL Thanks a lot! Richard

Yesterday was a big day! Gopro Zenmuse install TX / RX swap to Futaba T8J setup with SBUS / fatshark 25mw Video TX internal install with spironet. Followed all the guidance videos from HPI Guy on the TX / RX swap to Futaba T8J - many thanks! Followed official Zenmuse install video..all went...