I bought my Phantom 1 with the Zenmuse Gimball installed and it worked fine. After a crash and repair it now is very sensitive. When I power up it goes through the calibration routine OK and responds to the radio control, but any bump at all disables the gimbal and it goes dead until a restart...
The antenna area gets really hot. I tried to recalibrate with software and before it can complete the IMU reset it says that it's over temperature. Also compass reads 0,0,0 so there's an issue there...
I recently crashed my P2 (Non Vision) and had to replace the shell. All components re-installed but now compass is not working and GPS is overheating. Any ideas?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.