Recent content by RAWONE

I installed the Futaba TJ8 recently. Followed "ThatHPIguy" videos. One difference was no 3 position switch on left, so I assigned the 2, 3 position switches on right side for IOC and GPS/Att/Manual. All good so far. When hooked up and launched Naza Assistant, it no longer shows GPS on U bar...

The 20 meter climb during initiation of RTH is important to where and how I fly. For some reason this has recently stopped working. I went into the NAZA assistant and it shows 2 graphics...1= direct RTH at existing altitude and the decent, 2= Climb 20 meters, RTH and decent. Assistant won't...

Scratch that request. Just noticed there is a separate driver for win 8. worked fine.

I used to have to borrow a PC (I'm a Mac guy) to calibrate the phantom. Went and bought a cheap PC with win 8 already loaded. Cheaper than parallels, Win 8 builder etc. Downloaded NAZA assistant and driver and it doesn't recognize the phantom. Uninstalled and reinstalled both several times and...

I used to have to borrow a PC (I'm a Mac guy) to calibrate the phantom. Went and bought a cheap PC with win 8 already loaded. Cheaper than parallels, Win 8 builder etc. Downloaded NAZA assistant and driver and it doesn't recognize the phantom. Uninstalled and reinstalled both several times and...

I honestly don't recall the blinking sequence. That's the funny thing though, it held lat/long almost dead on. just would not return from altitude of 500' or so. From my reading of instructions, doesn't matter what mode you are flying in for RTH to function if signal is lost. Since that crash...

First Flight yesterday. Thought I followed all instructions. 1st noticed drift in GPS mode. When I took it to high elevation, it stoped responding to inputs. Figured it would engage RTF. Nope! Shut off transmitter to engage RTF. Still no. It maintained it's position until battery low, descended...

First Flight yesterday. Thought I followed all instructions. 1st noticed drift in GPS mode. When I took it to high elevation, it stoped responding to inputs. Figured it would engage RTF. Nope! Shut off transmitter to engage RTF. Still no. It maintained it's position until battery low, descended...

I'm in Ct (Stamford) but brand new as well.