Recent content by Raptor

Yes you can use the stock charger to connect 3 batteries using this strip. But you need to spend 3 times the normal charging time. If you want to charge multiple batteries faster, you need to increase the amp. I can only charge up to 5.5 amp per battery (i.e. 16.5 amp for 3 batteries)...

It is always good to learn more about lipo batteries. These are two useful sites: Understanding Lipo batteries: http://www.rchelicopterfun.com/rc-lipo-batteries.html Parallel charging : http://www.rchelicopterfun.com/parallel ... rging.html

"upgrade" or "downgrade" means the same thing: reinstall the firmware of your P2 using a different version of the Phantom Assistant. Example 1: connect your P2 with Phantom Assistant Version 1.08 and you can choose to "upgrade/downgrade" your P2 to Version 1.08 Example 2: connect your P2...

I have experienced the same problem and post here myself asking for help. Turns out I resolve the problem by using the following method: To calibrate X1, you have to follow VERY STRICTLY the steps recommended by DJI: 1. Calibrate the stick in the RC Assistant (note that X1 cannot be...

To calibrate X1, you have to follow VERY STRICTLY the steps recommended by DJI: 1. Calibrate the stick in the RC Assistant (note that X1 cannot be calibrated in RC Assistant); 2. Calibrate X1 through Phantom Assistant. If you do step 2 first, you will have no control on X1 no matter how many...

Re: Frimware Updates - Lessons Learned - 1.08 vs Anything El To calibrate X1, you have to follow VERY STRICTLY the steps recommended by DJI: 1. Calibrate the stick in the RC Assistant (note that X1 cannot be calibrated in RC Assistant); 2. Calibrate X1 through Phantom Assistant. If you...

I have updated all firmware including the BTU. I can't get any green light between my ground side and air side. I know I have to wait until the GS app is being updated. However, am I suppose to get the air side and ground side linked now?

That's probably because of the latest RC firmware 1.0.1.12. I have the same issue after updating. The previous version 1.0.1.11 was fine. Not sure why the new one make it worse. Any solution?

KSC, I understand the antenna of air side should be pointing at different directions by 90 degree with one pointing downwards. Yours are pointing at the same directions. Would this affect the range of your reception?

I am stuck as well ...

The Assistant Software still shows v.1.08 as the latest main controller version. Can't update it now

Guys, you can capture snapshots of your video taken by your GoPro by simply using the VLC Player to play your GoPro video. This way, you can just set up your GoPro for video mode only and then capture whatever shot you want through the VLC Player. The quality of the photos are still good...

The gimbal on/off switch is for people using third party gimbal. If you are using H32D, you should turn this to 'OFF'

http://www.dji.com/dji-released-the-fpv ... phantom-2/

The IOSD mini and the Bluetooth datalink are two separate system with no connection with each other. You can only connect your iosd mini with your 5.8 TX in order to use it's function.