I had a really hard time removing my lens cap so I used scissors and cut it way down. It works perfect and still holds good, however, it comes off like it should. Now I fell like Im NOT ripping the gimbal apart when I remove it. Attached is a photo.
They make an epoxy for plastics. I have had very good luck with it. You can get it at walmart. I use 2 layers. First layer to glue it and then a second to coat the first layer.
Not sure about the switches above. I could be wrong, but the link might be for a momentary on. example: (on) off (on). I think the correct switch is: On-off-On Someone chime in ???
Thanks for all the help, I will call Hobby Wing. If they dont have it, I will get it soldered or silicone the pins in as the pins still work.
Thanks for the input.
What connector is this? Its the transmitter for the Phantom 3 standard. The connector that plugs into this is broken. The battery plugs in here, anybody know where I can get a plug ????
Brand new P3S. Installed the newest firmware. Going through the DJI GO app and am ready to go, I set my new controller on tv tray wife was using with her labtop. She spins her computer around "Hey Rick" as I watch my new controller fall and hit the floor breaking off the S2 switch. Ok no problem...
For sale: 3each phantom 2 batteries, one new dji oem charger, one car charger which is aftermarket and a charge bar to charge three batteries all at once. See ebay ad. It ends Monday, 11:05PM
See ebay auction link below. Copy and paste into your browser.
3x DJI phantom 2 batteries vision...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.