Fly inside my house all the time. I do have a larger home with some bigger rooms. Does a nice job sucking the cobwebs out of the corners of the room :lol:
First get experienced outdoors. Second get the prop guards with the string so if you do bump a wall it won't crash and die. Finally always...
[facepalm] That's my point, it didn't come with a manual and there are a large number of people who either didn't know they could download it or didn't bother. That's why they didn't know about the gopro wifi!
Strange...my manual doesn't say that probably because mine never came with one. I had to download it from their website. It also doesn't read like that either. It says: "Make sure there is no other wireless device which may interfere in flight, such as a GoPro3, high power broadcasting, signal...
I would have to believe that most are caused by pilots who don't set a home point, don't calibrate the compass, use the gopro wifi or don't change batteries in their controllers. People need to spend enough time reading and operating low level, close to home flights to get used to what the...
I had lots of trouble (Win 7, 64bit)
I had to reinstall the driver each time to get it to work. Finally now it works. Make sure you connect the battery and the USB before opening the software.
If you do the software upgrade it changes a lot of the settings. Go through and make sure settings...
Phantom v1.1.1
Gopro3+ w/ go pro case
carbon fiber anti jello mount
stock props
stock Phantom 2200 battery
prop guards w/ protective string in place
around 7 minutes til first warning triggered (7:15 w/ stock DJI gopro mount instead of gopro case)
Red/Yellow is telling you there is an issue and you DO NOT want to fly. Try calibrating the compass. Switch the GPS/ATTI switch up and down 8 times and the light goes steady. rotate the copter 360 degrees until the light blinks green. Now turn it on its side and rotate it that way 360 degrees...
12.36 volts after 18 hours on the charger
Protections set to
1st level 11.55v 0.00 loss 11.55 Loaded - Safeguard LED Warning
2nd level 11.10 v 0.00 Loss 11.10 Loaded - Safeguard Descending
Took it up and it ran 1minute, 34 seconds before red lights turned on. It lost power and had to...
I do have a voltmeter. What is fully charged?
I will check the settings
Fully charged than take it off or keep it on the charger fully charged. That question was pretty much answered, leave it off the charger.
I have a few questions. I was unable for a few days to tell if my battery was running out due to a setting in the software set wrong so I ended up landing/softly crashing due to dead battery. I read running this low can damage the battery. Well I now charge which takes only about 30 minutes but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.