Recent content by privy

So I have a Phantom 2 Vision for sale. It has been sitting in my closet for a while because it has the no fpv issue with the fc200(egg) camera. It still had gps , telemetry, etc. when connected to the camera. I attempted to fix the issue and have bricked the camera board while doing so. The...

Offers? Sent from my D6708 using Tapatalk

Judging interest and how much possible cash for my phantom vision, rotorpixel gimbal, 2 batteries with over 90% life let I believe, vision+ landing gear installed(have original as well),filter kit and 3 filters, few sets of both 9443 and 9450 props, a new esc to fix a faulty led, and original...

Yea have it set to 100. Definitely more responsive that way but when turning on the phantom it goes all the way down or up. Might just make sure when starting up just have it go up.

So I got my 7th channel lever working with rotorpixel gimbal pretty descendtly. Only thing is when I turn the P2V the gimbal shoots the camera all the way up or all the way down. I've tried to have the lever centered when I turn it on but still really doesn't make a difference. Anyone else have...

Looks like stock landing gear cut and glued to the installed gear. May be wrong but that's what my eyes see. I do like that idea. I've been looking for inventive ways to extend my stock landing gear. I'm just not a fan of the look of the wider and taller ones.

I just had the same problem and it turned out to be a bad motor. My LEDs would light up on the initial startup but when I turned the motors on the one didn't light up. Tested by swapping with a working motor and the problem followed where I put the bad motor.

Re: Bad motor or esc? Just for an update, I figured out it was not the ESC board and was the motor. Taught myself some of the skill of soldering and swapped the motors to test and guess it must be a bad motor since it did the same thing where I transferred it to. Oh well now I'll just have a...

Thanks for the info. Going to do some practicing today. Ordered a new esc board on a hunch. Saw a slight imperfection where the motor wires are soldered to the esc

Yea watched a couple videos and what not. Read something about an unsoldering iron. Necessary?

Well going out to buy a soldering iron and see if I can get things to start happening. Any tips on what kind of soldering iron, do I need solder or is there enough to reuse?

Re: Bad motor or esc? Well I've never actually soldered anything and don't really want to screw anything up. Seems like it would alot of soldering for a first timer

Looking to fix my p2v and just not sure what to fix. I flew it fine to test my new rotorpixel gimbal and then I tried to take it up for a sunset flight but one motor was a no go. The motor barely spins but when it's off it seems to spin freely. The esc lights work when turning the quad on...

Yup mine is too!

3465 has shipped. Oh happy days. [emoji106]