Recent content by pixmanlajunta

I agree with the frustration! I've had it almost 2 weeks now and haven't gotten to fly it. I hope I get to try before warranty runs out! Also a lot of newb in the time lapse so can't blame the equipment. ® :twisted:

Thanks, Peter! As I am new at this (I bought the setup last week for aerial photography as I am a photographer first and foremost) I am kind of casting about. The Phantom 2 software for Mac does not see the copter, nor was it visible when I went to a friend's house and tried on his Windows 8...

I have finally got the copter to make everything seem to work on my new Phantom 2 except the H3-3D Gimbal. It gets very hot after about 5 minutes. It seems to want to point to a compass direction instead of straight forward. As the copter rotates the gimbal does not. When it gets to the extreme...

Wow Thanks!

I am a newb and have assembled the Zenmuse H3-D3 on the PHantom 2. I want to take it back off. I am pretty sure that I will break those clear plastic anti drop pins or the plastic washers when I do it. I am trying to find replacements for them, or what to do to replace them, BEFORE I break them...

Thank you!

The USB port on the outside of the Phantom 2 case ends in a 4 port plug. It is not plugged in. Where does that go? Thanks again. Robert

Thank you so much for your help. It looks like everything pretty much went in the same place as the previous "Phantom" FC. One more question. The USB port on the outside of the case ends in a 4 port plug. Where does that go? Thanks again. Robert

I'm not sure what "CAN module" CAN module=Newb for CANBUS lol

I hope that helps some, it seems like you might be overcomplicating things a bit in your mind ;) Thank you, I will give it a look. I am a computer repair person and thought this should be easy. But this is a whole new area of knowledge that you guys have. Props!

Yes, I am a complete mess. I am trying to install the following... NAZA-M v2 and the ipad Groundstation air module. I am completely lost and fully aware that I probably have all kinds of things wrong. I did think I had the NAZA in correctly though. If there is any way to get me correct...

I'm new at this. I have looked all over the net and through all of the manuals and can find nothing. I am trying to install a NAZA-M v2 to my Phantom 2 (Non-Vision). Perhaps if one or more of you who are more advanced could identify by number the ports on the board I might be able to figure...