Recent content by Piranha

Can you make a sketch where you measured? I still can not understand what was shorted and how come it could be? Is it shorted incise a Jack wire or in the connector?

To check right direction of motors you need to push AUTO button on the GUI software, when doing it try to hold your gimbal firmly, without movement, and with a clearance around camera (just hold your phantom horizontally, little bit over your table) after some movements of the camera, software...

Licensed firmware uploaded to the board, but for fine tune and change some settings you just need to download gui software from basecam web page

It only means that alexmos controller is working good and there is a physical connection between naza and gimbal board is ok! I am not 100% sure how signal transferring. My initial thought was that iPhone app just transmit signal not to the camera but to the phantom transmitter and then...

go to the phantom gimbal settings page and change pitch gain from 20 to zero

It should not affect your pitch behavior from application, hm rc-settings looks ok Did you set phantom gimbal gain setting to zero in Phantom assistant?

Hey, i am sure that it is just unselected rc-settings rc-pich checkbox in basecam software, can you make screenshot of "rc-settings" menu from basecam gui?

Wow Man, you have iron balls :) I am not so brave flying over the river (especially after one of my big hex Is scarifying fishes on the bottom of a big lake for more then one year already :))))

Quite good result, still can see some small roll axis vibes but you can fine tune it :) Decrease a little bit p and maybe D on roll

It ca not trashed something in your camera because it is just wire extender goes to your camera transferring same voltage and signals from Phantom original wire!

If everything checks fine it should work 100% just once again plug the connector all the way!!! and don't forget to switch camera "on" switch

Can you check also 3.5 mm plug (is it soldered well to the small board) ? Hm, but for me it sounds strange-if gimbal itself powers on and work OK but camera does not it only means that power does not go to the camera (after plug) so can you also check continuity from onboard 3.5mm plug...

Man it is quite easy to check and fix I think If gimbal works itself ok It tells that power is going from phantom to the board through the 3.5 jack plug ok, so if camera won't power one It only mean bad connection of wire going from the board, just open cf cover, there should be main board and...

Guys, if you have vibrations like this just try to decrease phantom basic gains in phantom assistant

Man, your last video is really smooth!!! Good results!! Here is my last video, little bit edited, shortened and add some basic software stab just to get ride of yaw phantom hunting! http://www.youtube.com/watch?v=Nmy4rPGQDwI