Recent content by Phantom101

  1. P

    Please Help! Non-stop BEEP after PMU V2 install

    Very usefull information, thank you very much for your help. I'll do the Advanced IMU calibration exaclty how you described it and let you know the result. It was good you pointed out the solder joints, I'm no specialist in solder, actually it was my first time doing that, had kind of a hard...
  2. P

    Please Help! Non-stop BEEP after PMU V2 install

    You were right, I re-checked all my solder joints by pulling the wires a bit harder and one of them go loose. Re did it, and all worked fine. However, after my first test flights with the zenmuse I noticed the Phantom much more unstable when hoovering in GPS mode. I performed the compass...
  3. P

    Please Help! Non-stop BEEP after PMU V2 install

    Hi, I´ve just purchased a Dji Zenmuse H3-2d, I followed every instructions precisely to install it. Use PMU v2, but when I replace the X3 channel by the PMU v2 cable as instructed, I get a BEEP...BEEP...BEEP...BEEP...BEEP.. and it doesn't stop. If I replace the PMU v2 cable by the original...
  4. P

    Please Help! Non-stop BEEP after PMU V2 install

    Hi, I´ve just purchased a Dji Zenmuse H3-2d, I followed every instructions precisely to install it. Use PMU v2, but when I replace the X3 channel by the PMU v2 cable as instructed, I get a BEEP...BEEP...BEEP...BEEP...BEEP.. and it doesn't stop. If I replace the PMU v2 cable by the original...