Now have a initially a flashing red light on the RX board and when I push the tethering button i goes to a flashing green. I do have my remote turn on and close. Any ideas please
Yep .. just pulled the RX panel out and it sure has go a fault .... if you move the board when fail safe is on communication recommences ... DJI are providing a new board .... yeeee haaaaa
Thanks for your assistance
Pete
Thanks for that. It just confirms my diagnosis. Only had this 3 weeks and its been out of the air for a week of it. Lets see what I can get out of DJI ??http://www.phantompilots.com/posting.php?mode=reply&f=19&t=11735#
So appreciate your input cause I am flying blind !!! (More ways than one) Yes I believe its the reciever in the Phantom. I think I will buy one and try it from you link You have help with my decission making anyway.
Cheers
Petehttp://www.phantompilots.com/postin ... 9&t=11735#
Since up grading hardware/ software I now have an intermittent problem with my Rx TX. PV2 flies great for a round 1.5 minutes then losses comms ... goes into safe mode and returns with Rx TX every now and again making communication till around 5 minutes with them both turn on where all...
Where I cant get the continuous green light and obviously no flight detail on the monitor. I think that i managed to update the software but each time i connect it now to a computer I get a bad connection signal from the computer. This is on a Phantom 2 (non vision) with gopro and AVL 58. Not...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.