Recent content by parbar

Simple fix. Re-linked the controller

I keep getting a Battery Error and a Motor Overloaded error on my P3P. I updated the firmware to 1.11.20 but it doesn't seem to help.

Thanks. OK...I fixed it. I used the DJI Assistant 2 for Phantom (I used the 2018 version since mine is a v1, not sure if that's necessary, but it worked), plugged the USB between the drone and computer with the drone on, and refreshed (since I had current firmware) the current firmware. I...

On my P4P Pro V1 I get a "No Image Transmission Signal" when I try to adjust the video settings and the screen goes black and the Setting indicators go to NA. And then the gimbal starts yawing slowly back and forth left and right. . It does not record video on the card. It's worked fine for...

Re: How to fix a vibrating / shaking / crazy P2V+ camera gim Imreallyintoit (or others), Was your camera noticeably misaligned? Mine shakes in all three axes, but I don't see the camera misaligned with the half shaft. I presume you're talking about the picture(s) on page 3 of this post. Not...

I put a 1/2 inch piece of electrical tape over the lens and it works fine.

Re: How to fix a vibrating / shaking / crazy P2V+ camera gim npalen, I pretty sure he means the three screws holding the case on the back of the motor cover as shown in the photos on page 3 of the topic. Then you carefully pull back the circuit board to get to the ribbon cable.

Re: How to fix a vibrating / shaking / crazy P2V+ camera gim I appreciate your input.It levels up when powered on. It just is lethargic in responding to some of the side to side movement. It is like it wants to work but is slow in getting at it. It doesn't jitter or shake. It runs smooth -...

Re: How to fix a vibrating / shaking / crazy P2V+ camera gim I took those off. The half moon pin is level with the camera. So are you saying to forcibly pull the camera off the hub to put the JB Weld on it? I haven't taken the camera off yet.

Re: How to fix a vibrating / shaking / crazy P2V+ camera gim Okay, mine just did a light crash and I think the gimbal motor took a hit - the one you are talking about. It controls horizontal roll- right behind the camera. It still seems to work - partially. It's a bit slow and doesn't quite...

Thanks for all the great input! I have the icons overlapping the DJI icons in the upper right on my mini.

Re: Cheapest way to deal with barrel distortion automaticall Somewhere on the forums I learned about GIMP. It's free for the Mac or PC or Linux This site is for the Mac. http://the-gimp.en.softonic.com/ Search to get a PC site. It does a reasonable job on photos. Open it, load your pic and...

Is there any way to slow down the camera pitch or make it smoother using an iOS device with the slider or the gyro control? It does not seem to facilitate smoothness across the spectrum. Is there any adjustment for this?

Re: Getting DJI Vision App on iPad mini Thanks, I ended up syncing it with my computer that already had the DJI app on it from my iPhone.

Getting DJI Vision App on iPad mini How do I get the DJI Vision App on the iPad mini? I don't see it in the app store? It's on my iPhone but not the iPad mini.