I took the entire thing apart again last weekend and inspected the cable as well as all the connections. Everything looked good other than the cable separation. It seemed like the separated area grew bigger the more I messed with it. Do you know if this will impact the integrity of the cable?
I tried upgrading the firmware unsuccessfully. After some research I found that It's not possible to do a firmware update when the gimbal is "disconnected". The main ESC board is brand new. I just replaced it with a genuine part.
The ribbon cable was very difficult to install as it was my first...
Yes. I replaced with a DJI original cable. When I Power on the P3A, the gimbal moves around and then turns all the way to one side and twitches a bit. I’ve ensured that all the components are lined up properly but still getting the “gimbal disconnected” error. I’ve checked all connections...
My friend recently game be his badly crashed P3A. I had to replace almost everything on it including the main board. I just clipped all the motor, LED and power wires on the main board and soldered onto the new one. I bought it straight from a DJI dealer. It really wasn't that difficult and I...
Looking to purchase a P3A camera/Gimbal 2.7k. I just did a full rebuild of a crashed P3A. I replaced the ribbon cable on my existing camera but its just too thrashed. Thank You!!
I’m having the same issue with my gimbal. I recently did a large overhaul on a crashed P3A that a friend gave me. I replaced the main ESC board, OFDM receiver module board, top and bottom shell and I also disassembled the entire gimbal to replace the ribbon cable which had been torn in have. App...
I’m having the same issue with my gimbal. I recently did a large overhaul on a crashed P3A that a friend gave me. I replaced the main ESC board, OFDM receiver module board, top and bottom shell and I also disassembled the entire gimbal to replace the ribbon cable which had been torn in have. App...
Can someone point me in the right direction? I’m trying to find a video/instruction on installing the positioning system with the sensor board and OFDM board. Need to see how to route wire into everything and assemble it. I’ve looked everywhere with no luck! Trying to do a full assembly of a P3A...
Similar question. I replaced the flex cable on my P3A. The gimbal moves freely but it seems like it’s rubbing a bit on something when I move it around with my hand. Haven’t assembled everything yet to test. Has anyone else had this issue?
Hey guys, I’m new here so bare with me. I am replacing the ODFM module and WiFi antennas on my P3A. I see that the antennas are different. I see the numbers on the OFDM module board and the antenna themselves. My question is how do I know which antenna goes on each leg of the P3A stand? Or, does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.