My DJI Phantom 4 Pro V2.0 Remote Controller GL300K model just stopped linking with the aircraft. I have tried to downgrade the firmware to see if it works but I have not been able to downgrade. Is it possible to do so? Can a third party software solve the linking problem or do I throw the remote...
This link might enlighten you.
https://phantompilots.com/threads/connecting-the-compass-from-the-landing-gear-to-the-power-interface-module-in-the-phantom-4-pro-v2-0.148224/post-1482566
I bought the wrong legs and after comparing my old legs with new ones on amazon, I bought the right stuff. I just went through a similar thread with the same problem a guy had. He realized that by default DJI left one compass blank. So I can officially tell you that the P4PV2 flies with only one...
Thanks for clearing this issue up for me as well. I was going mad. I thought I had misplaced the cable not knowing that by default DJI purposefully left one compass port empty. Look at the attached. So can I say that it is safe to fly the drone using only one compass??
I understand. Thanks for your support. Much appreciated. Please do not abandon me though. I am guessing here. Do you think that the missing compass port plugs into one of the landing skid's. If so then I have been using the wrong one cause it does not have a port for a compass.
Hi I need help locating the port for the compass on the P4Pv2. I can only locate see the ports on the side main board but I do not know where the second one plugs into.
Can someone please send me a picture of the compass cables attached to the main board on a P4Pv2. I only have compass one working. I need to know where to plug in compass two. Apparently I bought the drone with only
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.