Recent content by Ombra

How do I go about doing that?

Both are set to NTSC but no luck ):

I have a P2 with iOSD, gopro 4 silver, zenmuse h3-3d, and a AVL5.8 vtx. I recently bought a black pearl off of craigslist and am having problems with it. The monitor came with one of the stock antennas and one Immersion 5..8 spironet antennas. It took some channel searching to begin with to get...

After trying a few things I found online, this one seems to work! I was starting to lose hope in printing my own and thought I'd need to order one from shapeways.

I have tried printing this one http://www.thingiverse.com/thing:526469 But haven't had much luck with it actually snapping onto the bottom rail of the remote or around the monitor itself. I'm a little worried about 3d printed parts for this.

I just got a black pearl monitor and have no idea how to mount it onto my remote. Any suggestions?

I know this is probably a dumb question, but couldn't find an answer anywhere online so I figured I might as well ask. So a friend of mine let me borrow his phantom 2 vision for the weekend and I was quite impressed with the potential of the DJI SDK for it. Not to mention android support for...

That's the antenna, does that look like it needs to be replaced?

Yeah, when it is in naza mode it goes back to the green red red red pattern. Any advice on getting out the stripped screw out? I'm worried about damaging the board being too rough with it.

That's the underside with my gimbal and vtx Here's the gps module, the last screw is stripped which is proving to be rather difficult to remove ): I have tried switching it to Naza mode, and it still blinks no/low satelites. Seller responded to my inquiry about the GPS, said that he didn't...

I haven't tried switching it back to naza mode since I assumed the two errors were equivalent for their own modes. The switch is definitely set to the top GPS mode.

Still at work so I haven't had a chance to poke and prod at the gps module, but I've gone back to look over the videos that the seller showed me before mailing it. Am I right to believe that it might have been broken before it was mailed out to me based on the LED pattern?

I'll take it apart when I get home. Besides visual inspection, is there any way else to tell if the GPS module is functioning?

To remove the GPS module, is it as simple as carefully peelimg off the padding to get to it?

I read the entire thread, I'm assuming you're referring to this part and not the having to ground and insulate right? I've drained a battery trying to get GPS lock, is there a way to force it to redownload the almanac and ephemeris? It came with an AVL58 vtx, gimbal and gopro, and I...